Welding Processes, mechanization and automation
Welding Economics.
Work Environment with welding
Metrology
Last planned examination: Autumn 2018
Decision to discontinue this course:
No information insertedWelding Processes, mechanization and automation
Welding Economics.
Work Environment with welding
Metrology
Upon completion of this course the student will have
MG110V Introductory Welding Technology, general course
MG111V Introductory Welding Technology, advanced course
MG112V Non-Destructive Testing
or corresponding
and Swedish B and English A
MG110V/MG1010 "Introductory Welding Technology, General Course"
MG1011/MG111V "Introductory Welding Technology, Advanced Course"
or equivalent
"Karlebo Svetshandbok (K Weman; In Swedish),
"Hälsa och säkerhet vid svetsning" (K Weman; In Swedish),
and handouts distributed during the course.
If the course is discontinued, students may request to be examined during the following two academic years.
Based on recommendation from KTH’s coordinator for disabilities, the examiner will decide how to adapt an examination for students with documented disability.
The examiner may apply another examination format when re-examining individual students.
Written examination (TEN1; 1,5 credits)
Lab work (LAB1; 3 credits)
Exercises (ÖVN1; 1,5 credits).
MG214V Advanced Welding Technology, module 2
MG215V Advanced Welding Technology, module 3
Only for non-KTH students. Students of a programme or exchange students at KTH should take MG2013.