Publications by Joachim Claesson

Peer reviewed

Articles

[1]

M. L. Fasci et al., "Temperature of energy boreholes accounting for climate change and the built environment - A new model for its estimation," Renewable energy, vol. 202, pp. 1479-1496, 2023.

[2]

M. L. Fasci et al., "Simulation of thermal influence between independent geothermal boreholes in densely populated areas," Applied Thermal Engineering, vol. 196, 2021.

[3]

M. L. Fasci et al., "Analysis of the thermal interference between ground source heat pump systems in dense neighborhoods," Science and Technology for the Built Environment, vol. 25, no. 8, pp. 1069-1080, 2019.

[4]

J. Wallin and J. Claesson, "Analyzing the efficiency of a heat pump assisted drain water heat recovery system that uses a vertical inline heat exchanger," Sustainable Energy Technologies and Assessments, vol. 8, pp. 109-119, 2014.

[5]

J. Wallin and J. Claesson, "Improving heat recovery using retrofitted heat pump in air handling unit with energy wheel," Applied Thermal Engineering, vol. 62, no. 2, pp. 823-829, 2014.

[6]

J. Wallin and J. Claesson, "Investigating the Efficiency of a Vertical Inline Drain Water Heat Recovery Heat Exchanger in a System Boosted with a Heat Pump," Energy and Buildings, vol. 80, pp. 7-16, 2014.

[7]

H. Madani, J. Claesson and P. lundqvist, "A descriptive and comparative analysis of three common control techniques for an on/off controlled Ground Source Heat Pump (GSHP) system," Energy and Buildings, vol. 65, pp. 1-9, 2013.

[8]

J. Wallin, H. Madani and J. Claesson, "Run-around coil ventilation heat recovery system : A comparative study between different system configurations," Applied Energy, vol. 90, no. 1, pp. 258-265, 2012.

[9]

H. Madani Larijani, J. Claesson and P. G. Lundquist, "Capacity control in ground source heat pump systems Part I : modeling and simulation," International journal of refrigeration, vol. 34, no. 6, pp. 1338-1347, 2011.

[10]

H. Madani, J. Claesson and P. Lundquist, "Capacity control in ground source heat pump systems part II : Comparative analysis between on/off controlled and variable capacity systems," International journal of refrigeration, vol. 34, no. 8, pp. 1934-1942, 2011.

[11]

B. E. Palm and J. Claesson, "Plate heat exchangers : Calculation methods for single-and two-phase flow," Heat Transfer Engineering, vol. 27, no. 4, pp. 88-98, 2006.

[12]

J. Claesson, "Correction of Logarithmic Mean Temperature Difference in a compact brazed plate evaporator assuming heat flux governed flow boiling heat transfer coefficient," International journal of refrigeration, vol. 28, no. 4, pp. 573-578, 2005.

[13]

J. Claesson, "The influence of brine flow on the flow boiling refrigerant heat transfer coefficient in a compact brazed plate heat exchanger," International Journal of Heat Exchangers, vol. 6, no. 1, pp. 35-54, 2005.

Conference papers

[14]

M. L. Fasci et al., "Shallow Geothermal Heat Pumps: a study of the resource potential at a neighbourhood scale.," in ICNTSE 2018, 2018.

[15]

J. Claesson, "Performance Evaluation of Combined Heat Sources for Innovative Heat Pumps : Ground Source Combined With an Air Coil, Paper ID 650," in CLIMA 201311th REHVA World Congress & 8th International Conference on IAQVEC, Prague, Czech Republic, 2013.

[16]

J. Wallin, D. Bastien and J. Claesson, "The influence of energy conservation on the performance of solar thermal systems - A cold country case study," in 1st International Conference On Solar Heating And Cooling For Buildings And Industry (SHC 2012), 2012, pp. 1069-1078.

[17]

H. Madani et al., "Experimental Analysis of a Variable Capacity Heat Pump System Focusing on the Compressor and Inverter Loss Behavior," in Proceeding International Refrigeration and Air Conditioning Conference, 2010.

[18]

J. Wallin, H. Madani and J. Claesson, "Run-around coil ventilation heat recovery system : A comparative study between different system configurations," in ICAE 2010 – International conference on Applied energy – Singapore 21‐23 April 2010, 2010.

[19]

H. Madani et al., "The Ground Source Heat Pump : A System Analysis With a Particular Focus on The U-Pipe Borehole Heat Exchanger," in 2010 14th International Heat Transfer Conference, Volume 4, 2010, pp. 395-402.

[20]

J. Wallin, H. Madani and J. Claesson, "Ventilation heat recovery with run around coil : System analysis and a study on efficiency improvement – Part I," in ASHRAE Region-At-Large conference. Kuwait. 3-5 October 2009, 2009.

[21]

J. Wallin, H. Madani and J. Claesson, "Ventilation heat recovery with run around coil - System analysis and a study on efficency improvment - Part I," in Ashrae - Symposium on “Sustainability and Green Buildings”, October 5, 2009, KUWAIT, 2009.

[22]

H. Madani, J. Claesson and P. Lundqvist, "Variable capacity heat pump systems, modeling and simulation," in 9th International Energy Agency Heat pump conference, 2008.

[23]

H. Madani, P. Lundqvist and J. Claesson, "Variable capacity heat pumps, modelling and simulation," in IEA Heat Pump conference Proceeding (2008) 9th International Energy Agency Heat Pump Conference, 2008.

[24]

J. Claesson, "Adiabatic two-phase flow hydraulic performance in a compact brazed plate heat exchanger," in Heat SET : Heat Transfer in Components and Systems for Sustainable Energy Technologies, 2007.

[25]

J. Claesson, "Performance of compact brazed plate heat exchanger operating as condenser in domestic heat pump system : An experimental investigation," in International Energy Agency Heat Pump Conference : Global Advances in Heat Pump Technology, Applications, and Markets, 2005.

[26]

B. E. Palm and J. Claesson, "Plate heat exchangers, calculation methods for single- and two-phase flow," in ICMM 2005, Proceedings of the 3rd International Conference on Microchannels and Minichannels, Pt A, 2005, pp. 103-113.

[27]

J. Claesson, "Thermal and hydraulic characteristics of brazed plate heat exchangers - Part I : Review of single-phase and two-phase adiabatic and flow boiling characteristics," in ASHRAE Transactions 2005, Vol 111, Pt 1, 2005, pp. 822-833.

[28]

J. Claesson, "Thermal and hydraulic characteristics of brazed plate heat exchangers - Part II : Current research on evaporators at KTH," in ASHRAE Transactions 2005, Vol 111, Pt 1, 2005, pp. 834-845.

[29]

J. Claesson, M. Afghani and B. Palm, "Influence of large temperature difference in a compact brazed plate evaporator with low overall heat flux," in Eurotherm no. 72: Thermodynamics, Heat and Mass Transfer of Refrigeration machines and heat pumps, 2003, pp. 33-37.

[30]

J. Claesson and B. Simanic, "Pressure drop and visualization of adiabatic R134a two-phase flow inside a chevron type plate heat exchanger," in 21st Int. Congr. of Refrigeration, 2003.

[31]

J. Claesson and M. Forsén, "Capacity control of a domestic heat pump : Part 1 – Performance of the heat pump and its components," in IIR/IIF Zero Leakage – Minimum Charge, Efficient Systems for Refrigeration, Air Conditioning and Heat Pumps, 2002, pp. 367-376.

[32]

M. Forsén and J. Claesson, "Capacity control of a domestic heat pump : Part 2 System modelling and Simulation," in IIR/IIF Zero Leakage – Minimum Charge, Efficient Systems for Refrigeration, Air Conditioning and Heat Pumps, 2002, pp. 377-383.

[33]

J. Claesson and B. Palm, "Discrepancy between calculated and measured superheated area in an evaporator plate heat exchanger," in HEFAT 2002, 1st Int. Conf. on Heat Transfer, Fluid Mechanics and Thermodynamics, 2002, pp. 1079-1086.

[34]

J. Claesson and B. Palm, "Boiling mechanism in a small compact brazed plate heat exchanger (CBE) determined by using thermochromic liquid crystals (TLC)," in 20th Int. Congr. of Refrigeration, 1999.

Non-peer reviewed

Articles

[35]

J. Claesson and J. Stare, "Bergvärme kombinerat med uteluftkonvektor – Förbättrad SPF i stadsdelar med hög andel bergvärme," KYLA+ Värmepumpar, 2014.

[36]

J. Claesson, "Kombisystem : uthållig uppvärmning av mindre fastigheter," Energi & Miljö, no. 12, pp. 68-72, 2008.

[37]

J. Claesson, "Butiken i kyllabbet på IUC har öppnat," ScanRef, no. 4, pp. 44-47, 2006.

[38]

J. Claesson and J. Rogstam, "Den fullskaliga testbutiken i miniatyr har öppnat," Kyla+, no. 8, pp. 41-43, 2006.

[39]

J. Claesson, "Plattvärmeväxlare som förångare, jämförelse mellan förångare med och utan fördelningsanordning," Kyla, no. 3, pp. 41-43, 2002.

Conference papers

[40]

H. Madani, J. Claesson and P. lundqvist, "Retrofitting a variable capacity heat pump to a ventilation heat recovery system : modeling and performance analysis," in International Conference on Applied Energy, 2010.

[41]

H. Madani, J. Wallin and J. Claesson, "Ventilation heat recovery with run around coil : System analysis and a study on efficiency improvement – Part II," in ASHRAE Region-At-Large conference. Kuwait. 3-5 October 2009, 2009.

[42]

J. Claesson, "Local flow boiling experiments with refrigerant R134a in compact brazed plate heat exchanger," in Annual Meeting of Danish Refrigeration Association. Odense, Denmark. March 15 – 16, 2007, 2007.

[43]

J. Claesson and B. Palm, "Performance of a compact brazed plate heat exchanger evaporator run in co-current and counter-current," in 5th International Conference on Boiling Heat Transfer, 2003.

[44]

J. Claesson, B. Palm and O. Pelletier, "On the influence of geometry on evaporation in compact brazed plate heat exchangers," in ICMF-2001 4th International Conference on Multiphase Flow, 2001.

Books

[45]

H. Havtun, P. Bohdanowicz and J. Claesson, Sustainable Energy Utilization. Stockholm : KTH Energiteknik, 2021.

[46]

J. Claesson, Thermal Comfort and Indoor Climate. 6th ed. Stockholm : KTH Energiteknik, 2021.

[47]

J. Claesson, Thermal Comfort and Indoor Climate. 5th ed. Stockholm : KTH Energiteknik, 2020.

[48]

J. Claesson, Thermal Comfort and Indoor Climate. 4th ed. Stockholm : KTH Energiteknik, 2019.

[49]

J. Claesson, Thermal Comfort and Indoor Climate. 3rd ed. Stockholm : KTH Energiteknik, 2018.

[50]

J. Claesson, Thermal Comfort and Indoor Climate. 2nd ed. Stockholm : KTH Energiteknik, 2017.

[51]

J. Claesson, Thermal Comfort and Indoor Climate. 1st ed. Stockholm : KTH Energiteknik, 2016.

Chapters in books

[52]

J. Claesson, "Chapter 2 - Köldmedier," in VVS 2000 TABELLER & DIAGRAM : Kylteknik, Energi- och Miljötekniska Föreningen Ed., Stockholm : EMTF Förlag, 2016, pp. 10-32.

[53]

J. Claesson, "Chapter 5 - Aggregat," in VVS 2000 TABELLER & DIAGRAM : Kylteknik, Energi- och Miljötekniska Föreningen Ed., Stockholm : EMTF Förlag, 2016, pp. 48-52.

[54]

J. Claesson, "Chapter 7 - Energieffektivitet," in VVS 2000 TABELLER & DIAGRAM : Kylteknik, Energi- och Miljötekniska Föreningen Ed., Stockholm : EMTF Förlag, 2016, pp. 59-70.

[55]

J. Claesson, "Chapter 9 – Miljö- och livscykelaspekter," in VVS 2000 TABELLER & DIAGRAM : Kylteknik, Energi- och Miljötekniska Föreningen Ed., Stockholm : EMTF Förlag, 2016, pp. 111-114.