Skip to main content
Before choosing courseMG117V Machining for Production Engineers 22.5 creditsAdministrate About course

The aim of this course is to give students both theoretical and practical applicable knowledge in the production technology. The aim is to upgrade the individual's particular skills, while the status of the production technology in society is strengthened.

Course offering missing for current semester as well as for previous and coming semesters
* Retrieved from Course syllabus MG117V (Autumn 2007–)

Content and learning outcomes

Course contents

No information inserted

Intended learning outcomes

No information inserted

Course Disposition

No information inserted

Literature and preparations

Specific prerequisites

General entrance requirements, i e completed upper secondary edcucation incl documentet proficiency in English and Swedish).

Recommended prerequisites

Basic knowledge in mathematics is recommended

Equipment

No information inserted

Literature

No information inserted

Examination and completion

If the course is discontinued, students may request to be examined during the following two academic years.

Grading scale

A, B, C, D, E, FX, F

Examination

  • LAB1 - Laboratory Work, 1,5 hp, betygsskala: P, F
  • PRO1 - Project, 9,0 hp, betygsskala: P, F
  • RAP1 - Report, 6,0 hp, betygsskala: P, F
  • SEM1 - Seminars, 3,0 hp, betygsskala: P, F
  • TEN1 - Examination, 3,0 hp, betygsskala: A, B, C, D, E, FX, F

Based on recommendation from KTH’s coordinator for disabilities, the examiner will decide how to adapt an examination for students with documented disability.

The examiner may apply another examination format when re-examining individual students.

Opportunity to complete the requirements via supplementary examination

No information inserted

Opportunity to raise an approved grade via renewed examination

No information inserted

Examiner

Profile picture Ove Bayard

Ethical approach

  • All members of a group are responsible for the group's work.
  • In any assessment, every student shall honestly disclose any help received and sources used.
  • In an oral assessment, every student shall be able to present and answer questions about the entire assignment and solution.

Further information

Course web

Further information about the course can be found on the Course web at the link below. Information on the Course web will later be moved to this site.

Course web MG117V

Offered by

ITM/Production Engineering

Main field of study

Mechanical Engineering, Technology

Education cycle

First cycle

Add-on studies

No information inserted

Contact

Ove Bayard, tel. 08-7906360 , e-post oveb@iip.kth.se